
INC.
Please read entire instructions before proceeding.
Step A Bull 3 Ways
Improper installation will void any applicable warranty.
Installation Instructions
3700 W. Pratt Ave. Lincolnwood, IL 60712-2508 Phone: (847) 679-3000 Fax: (847) 679-3017 www.trim-tex.com
Step 1: When using ½" drywall you will need
to set the drywall back a ½" for the / Radius
Step A Bull and a full 1" for the 1 ½" Radius
StepABull.
3
4
"
Step 2: For the 1 ½" Radius Step A Bull, you
may have to shave the corner down with a
hand saw, as shown in the picture above, for a
flush fit.
Step 4: Snip back the mud legs up to the
mud bump to prevent overlapping of beads.
Step 5: Install the Step A Bull Beads with
divergent staples every 6" and Trim-Tex 847
Spray Adhesive.
½”Step 3: Install the 3 way corner with
divergent staples and Trim-Tex 847 Spray
Adhesive.
½”
Corner trimmed for a
flush fit.
Paso 1: Cuando use tabla roca de ½” tendrá que
retroceder la tabla roca ½” para el StepABull de ¾”
y 1”para el StepABullde 1 ½”.
Paso 2: Para el Step A Bull de 1 ½”, tal vez tendrá
que cortar un poco la esquina con una sierra, como
se indica arriba, para un mejor ajuste.
Paso 4: Corte en ángulo las extremidades para
prevenir que un esquinero este montado sobre el
otro.
Paso 5: Instale los esquineros Step A Bull con
grapas de ½” y Adhesivo en Aerosol 847 de Trim-
Tex.
Paso 3: Instale la esquina 3-way con grapas de
½” y Adhesivo en Aerosol 847 de Trim-Tex.
Step 6: Finish the installation by mudding, sanding and painting the bead as you normally would any other bead.
Paso 6: Acabe la instalación poniendo el compuesto, lijando y pintando el esquinero como lo haría con el resto de los esquineros.
STYLE
3 WAY FOR / "
3
4
STOCK # PCS/ BOX
995
15
3 WAY FOR 1 ½’
996
15
#995
#996
Comentarios a estos manuales